HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 241

Flags
nbrWWN
red_ports
Operands
This command has the following operands:
slotnumber
portnumber
Fabric OS Version 3.1.x/4.1.x Reference Guide
Port flags:
0x00000001 slave connection
0x00000002 loop back connection
0x00000004 incompatible connection
0x00000008 overlapping domains
0x00000010 overlapping zones
0x00000020 done PTIO ioctl
0x00000040 sent a RJT to ELP
0x00000080 BF received from the port
0x00000200 segmented by routing code
0x00000800 zoning has completed
0x00001000 segmented by Platform Management
0x00002000 segmented due to no license
0x00004000 segmented due to E_Port disabling
0x00008000 DIA already sent for that port
0x00010000 RDI already sent
0x00020000 port is true T port
0x00040000 Port received an ELP
0x00080000 Port received an ELP RJT
0x00100000 LR Pending due to ELP RJT rcv
0x00200000 Received a DIA on this port
0x00400000 Port is the EMT Initiator
0x00800000 Security violation
0x01000000 Security incompatibility
0x02000000 Rcv a DIA ACC
Neighboring switch's WWN
All E-Ports that are connected to the same neighboring switch.
Specify the slot number for a StorageWorks Core switch. For all
other switches this operand is not required. The slot number must
be followed by a slash ( / ) and the port number, so that each
port is represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10 slots. Slot
number 5 and 6 are control processor cards, and slot 1 through
4, and 7 through 10, are port cards. On each port card, there
are 16 ports counted from the bottom, 0 to 15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is required.
fabportshow
241