HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 24

Fabric OS Commands
There are six Access Control Lists (ACLs) to restrict SNMP get/set/trap
operations to hosts under a host-subnet-area. Host-subnet-area is defined by
comparing non-zero IP octets. For example, an ACL of "192.168.64.x" enables
access for any hosts that start with the specified octets. The connecting host is
enabled as "192.168.64.xx," where xx is any number from 0 to99. All ACL entries
also have a flag to set each host-subnet-area to be read-write or read-only. The
highest privilege matched out of six entries is given to the access. An ACL check
is turned off when all six entries contain "0.0.0.0."
Note:
into the WSNMP (WinSNMP) and Reliable SNMP (RSNMP) security policies.
Community strings can be changed on the primary FCS switch only and will propagate
changes across the fabric. See
Operands
None.
Example
To set the SNMP agent configuration parameters to default values, and verify they
were set:
switch:admin> agtcfgDefault
*****
This command will reset the agent's configuration back to factory default
*****
Current SNMP Agent Configuration
Customizable MIB-II system variables:
sysDescr = Fibre Channel Switch.
sysLocation = End User Premise
sysContact = sweng
sweventTrapLevel = 0
authTraps = 1
(continued on next page)
24
When secure mode is enabled, the Access Control List feature is incorporated
"Security Commands" on page 941.
Fabric OS Version 3.1.x/4.1.x Reference Guide