HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 383

The final prompt allows you to set the new IP addresses immediately. Enter Y to
set new addresses immediately; enter N to delay the changes until the next switch
reboot. Entering Y closes the telnet session.
A change to these values issues a domain address format RSCN; see FC-FLA for
a description of RSCNs.
Operands
For V3.1.x, none.
For V4.1.x, this command has the following operand:
option
Example
To set the IP address details for a switch (V3.1.x example):
switch:admin> ipAddrSet
Ethernet IP Address [0.0.0.0]: 192.168.166.148
Ethernet Subnetmask [0.0.0.0]: 255.255.255.0
Fibre Channel IP Address [0.0.0.0]: 192.168.58.135
Fibre Channel Subnetmask [0.0.0.0]: 192.168.166.134
Gateway IP Address [0.0.0.0]: 192.168.166.135
Committing configuration...Done...
switch:admin>
Fabric OS Version 3.1.x/4.1.x Reference Guide
Press Ctrl-C to cancel changes
Press Ctrl-D to accept changes and end input
Specify which option you would like to configure. This operand
is only available for the StorageWorks Core switch. Valid
options are as follows:
If no operand is specified the command becomes interactive.
0 sets the Ethernet IP address, Ethernet subnetmask, Fibre
Channel IP address, and Fibre Channel subnetmask of
logical switch 0.
1 sets the Ethernet IP address, Ethernet subnetmask, Fibre
Channel IP address, and Fibre Channel subnetmask of
logical switch 1.
2 sets the Ethernet IP address, Ethernet subnetmask,
gateway IP address, and hostname of CP0.
3 sets the Ethernet IP address, Ethernet subnetmask,
gateway IP address, and hostname of CP1.
ipAddrSet
383