HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 751

Operands
This command has the following operands:
mode
-show
(V4.1.x only)
Example
To enable or disable GBIC mode (V3.1.x example):
switch:admin> setgbicmode 1
Committing configuration...done.
GBIC mode is now ON.
switch:admin> setgbicmode 0
Committing configuration...done.
GBIC mode is now OFF.
switch:admin>
To enable or disable GBIC mode (V4.1.x example):
switch:admin> setgbicmode 1
GBIC mode is now 1 (Enabled).
switch:admin> setgbicmode 0
GBIC mode is now 0 (disabled).
switch:admin> setgbicmode -show
GBIC mode is now 0 (disabled).
See Also
crossPortTest
spinSilk
Fabric OS Version 3.1.x/4.1.x Reference Guide
Specify 1 to enable GBIC mode or 0 to disable GBIC mode. For
V4.1.x, if no mode is specified the current value is displayed.
The mode is saved in non-volatile memory and remains
unchanged until the next execution of the setgbicmode
command. This operand is optional.
Specify the -show operand to display the current setting. This
operand is optional.
setgbicmode
751