HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 601

Internal unicast
routing table
Multicast routing
table
Broadcast routing
table
Operands
This command has the following operand:
slotnumber
(V4.1.x only)
portnumber
Fabric OS Version 3.1.x/4.1.x Reference Guide
Lists all ports in the local switch that a unicast frame can reach
from portnumber. Format is
destination_port: output_ports_bitmap
Because the destination_port is in the local switch,
output_ports_bitmap
bit position number representing the
number.
Shows multicast frame routing to the destination multicast
group. Output format is:
mcast_group_number: (mcast_group_id)
ports_bitmap
where
mcast_group_number
number
mcast_group_id
ports_bitmap
numbers that can forward a multicast frame from the
portnumber to mcast_group_id
A bitmap, containing all ports reachable by a received
broadcast frame. Bit 16 of the bitmap is always set to allow the
switch element to receive broadcast frames.
Specify the slot number for a StorageWorks Core switch.
For all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot
number (1 through 4, or 7 through 10), and port number
(0 through 15).
The StorageWorks Core switch has a total of 1–10 slots.
Slot number 5 and 6 are control processor cards, and slot 1
through 4, and 7 through 10, are port cards. On each port
card, there are 16 ports counted from the bottom, 0 to 15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is required.
usually contains one bit with a
destination_port
is the multicast group
is the multicast frame destination ID
is a hex bitmap of all output port
portRouteShow
601