HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 544

Fabric OS Commands
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
distance
(V3.1.x only)
544
Specify the slot number for a StorageWorks
Core switch. For all other switches this
operand is not required. The slot number must
be followed by a slash ( / ) and the port
number, so that each port is represented by
both slot number (1 through 4, or 7 through
10), and port number (0 through 15).
The StorageWorks Core switch has a total of
1–10 slots. Slot number 5 and 6 are control
processor cards, and slot 1 through 4, and 7
through 10, are port cards. On each port
card, there are 16 ports counted from the
bottom, 0 to 15.
Specify a port number. Valid values for port
number vary depending on the switch type.
This operand is required.
This operand indicates the distance to the
connected port. This operand is required. The
valid values for this operand are:
L0: Deconfigure the port to be a regular
switch port. This option supports up to
10-km links for 1 Gbps, or 5-km links for
2 Gbps.
LE: Level E mode is for E_Ports for
distances beyond 5 km and up to 10 km
especially for 2 Gbps link speeds. LE
does not require extended fabric license.
L1: Level one long distance, up to 50 km.
L2: Level two long distance, up to 100
km.
Fabric OS Version 3.1.x/4.1.x Reference Guide