HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 520

Fabric OS Commands
Operands
This command has the following operand:
slotnumber
(V4.1.x only)
portnumber
interval
Example
To display filter monitor traffic on blade 2 port 5 at an interval of every 6 seconds:
switch:admin> perfshowfiltermonitor 2/5, 6
perfShowFilterMonitor 2/5, 6
0 1
#Frames #CMDs
---------------------------------------------------------------
0 0
26k 187
26k 177
26k 184
26k 182
26k 188
26k 183
26k 167
26k 179
26k 164
26k 190
26k 181
26k 200
26k 180
26k 179
26k 187
26k 200
26k 204
520
Specify the slot number for a StorageWorks Core switch.
For all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot
number (1 through 4, or 7 through 10), and port number
(0 through 15).
The StorageWorks Core switch has a total of 1–10 slots.
Slot number 5 and 6 are control processor cards, and slot 1
through 4, and 7 through 10, are port cards. On each port
card, there are 16 ports counted from the bottom, 0 to 15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is required.
Specify an interval in seconds. This operand is optional.
2 3
#CMDs #Frames
0 0
681 682
711 710
734 734
649 649
754 755
716 716
657 656
749 749
752 752
700 700
701 701
750 750
692 692
696 696
720 720
722 722
717 717
4 5
#Frames #CMDs
0 0
682 494
710 534
734 550
649 467
755 567
717 534
655 488
749 570
752 588
700 510
701 520
751 550
691 512
696 517
720 533
722 522
717 513
Fabric OS Version 3.1.x/4.1.x Reference Guide
6
#CMDs
0
187
176
184
182
184
183
167
179
164
190
181
201
179
179
187
200
204