Configure Command Arbitrated Loop Settings - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

Fabric OS Commands
RSCN Transmission Mode
The RSCN Transmission Mode field is as follows:
End-device RSCN
Transmission Mode
NS Operation Parameters
The NS Pre-zoning Mode field is as follows:
Pre-zoned Responses
Mode
Arbitrated Loop Parameters
The Arbitrated Loop Setting fields are as follows:
Table 4: Configure Command Arbitrated Loop Settings
Alternate BB Credit? (V4.1.x only)
Send FAN frames?
Enable CLOSE on OPEN received?
Always send RSCN?
Do Not Allow AL_PA 0x00?
Initialize All Looplets? (V3.1.x only)
Descriptions of the Arbitrated Loop Parameter fields are as follows:
Send FAN frames?
Enable CLOSE on OPEN
received?
156
Specify 0 for RSCN with single PID, 1 for RSCN with
multiple PIDs, or 2 fabric RSCN. The default value is 0.
Specify 0 for Standard Mode, or 1 for Pre-zoning On.
The default value is 0.
Field
Specifies that fabric address notification (FAN) frames
be sent to public loop devices to notify them of their
node ID and address. When set to 1, frames are sent;
when set to 0, frames are not sent.
If this is set, a CLS is returned immediately to an OPN
if no buffers are available. This is required for
TachLite.
Default Range
0 0 or 1
1 0 or 1
0 0 or 1
1 0 or 1
0 0 or 1
0 0 or 1
Fabric OS Version 3.1.x/4.1.x Reference Guide