Show Rfdetect Counters - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Typ
Dst
Last Rogue Status
Check

show rfdetect counters

Displays statistics for rogue and Intrusion Detection System (IDS) activity detected by the
APs managed by a switch.
Syntax: show rfdetect counters
Defaults: None.
Access: Enabled.
Examples: The following command shows counters for rogue activity detected by a switch:
DWS-1008# show rfdetect counters
Type
--------------------------------------------------
Rogue access points
Interfering access points
Rogue 802.11 clients
Interfering 802.11 clients
802.11 adhoc clients
Unknown 802.11 clients
Interfering 802.11 clients seen on wired network
802.11 probe request flood
802.11 authentication flood
802.11 null data flood
802.11 mgmt type 6 flood
802.11 mgmt type 7 flood
802.11 mgmt type d flood
802.11 mgmt type e flood
802.11 mgmt type f flood
802.11 association flood
D-Link Systems, Inc.
Classification of the rogue device:
• rogue - Wireless device that is on the
network but is not supposed to be on the
network.
• intfr - Wireless device that is not part
of your network and is not a rogue, but
might be causing RF interference with AP
radios.
• known - Device that is a legitimate
member of the network.
MAC addressed to which the last 802.11
packet detected from the client was
addressed.
Number of seconds since the switch looked
on the air for the AP with which the rogue
client is associated. The switch looks for the
client's AP by sending a packet from the
wired side of the network addressed to the
client, and watching the air for a wireless
packet containing the client's MAC address.
RF Detection Commands
Current Total
------------ ------------
0 0
139 1116
0 0
4 347
0 1
20 965
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
344