D-Link DWS-1008 Cli Reference Manual page 171

8 port 10/100 wireless switch with power over ethernet
Hide thumbs Also See for DWS-1008:
Table of Contents

Advertisement

DWS-1008 CLI Reference Guide
set dap fingerprint
Confirms an DWL-8220AP's fingerprint on a switch. If DWL-8220AP security is required by
a switch, an DWL-8220AP can establish a management session with the switch only if you
have confirmed the DWL-8220AP's identity by confirming its fingerprint on the switch.
Syntax:
dap dap-num
hex
Defaults: None
Usage:
Examples:
DWS-1008# set dap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
set {AP | dap} group
Configures a named group of DWL-8220AP access points. MSS automatically load balances
sessions among the access points in a group. To balance the sessions, MSS rejects an
association request for an access point's radio if that radio has at least four more active
sessions than the radio of the same type with the least number of active sessions within the
group.
Syntax:
ap port-list
dap dap-num
D-Link Systems, Inc.
set dap num fingerprint hex
Number of the Distributed AP whose fingerprint you are confirming.
The 16-digit hexadecimal number of the fingerprint. Use a colon
between each digit. Make sure the fingerprint you enter matches the
fingerprint used by the DWL-8220AP.
Access: Enabled
DWL-8220APs are configured with an encryption key pair at the factory.
The fingerprint for the public key is displayed on a label on the back of the
DWL-8220AP , in the following format:
RSA
aaaa:aaaa:aaaa:aaaa:
aaaa:aaaa:aaaa:aaaa
If an DWL-8220AP is already installed and operating, you can use the show
dap status command to display the fingerprint. The show dap config
command lists an DWL-8220AP's fingerprint only if the fingerprint has been
confirmed in MSS. If the fingerprint has not been confirmed, the fingerprint
information in the command output is blank.
The following example sets the fingerprint for Distributed AP 8:
set {ap port-list | dap {dap-num | auto}} group name
List of DWL-8220AP access ports to add to the group.
Number of a Distributed AP to add to the group.
Access Point Commands
170

Advertisement

Table of Contents
loading

Table of Contents