D-Link DWS-1008 Cli Reference Manual page 110

DWS-1008 CLI Reference Guide
show snmp notify target
Displays SNMP notification targets.
Syntax: show snmp notify target
Defaults: None
Access: Enabled
Examples: To display a list of the SNMP notification targets, use the following command:
DWS-1008# show snmp notification target
Notify targets:
1: 10.10.40.99:162
user="remote-nmsuser", exists=no
engineID=ip
notify profile=default, exists=yes
security model=USM
security type=notify
notify type=INFORM
retry count=snmp-engine-id
timeout=1
The table below describes the fields in this display.
Field
user
engineID
notify profile
security model
security type
notify type
retry count
timeout
D-Link Systems, Inc.
Description
Name of the SNMP user.
SNMP engine ID associated with the user. For traps, the engine ID is local.
For informs, the engine ID is that of the notification receiver.
Name of the notification profile used by the target.
SNMP security model:
• v1
• v2c
• usm
Security requirements for exchanging messages with the target:
• unsecured - SNMP message exchanges are not secure.
• authenticated - SNMP message exchanges are authenticated but are not
encrypted.
• encrypted - SNMP message exchanges are authenticated and encrypted.
Type of notification sent to the target:
• inform
• trap
Number of times MSS will resend an unacknowledged inform.
Number of seconds MSS waits for acknowledgement of an inform before resending
the inform (if retries are available).
IP Services Commands
109