D-Link DWS-1008 Cli Reference Manual page 172

DWS-1008 CLI Reference Guide
dapauto
name
Defaults:
Access:
Usage:
Examples:
DWS-1008# set ap 1,4,6 group loadbalance1
success: change accepted.
The following command removes the DWL-8220AP access point on port 4 from all
DWL-8220AP access point groups:
DWS-1008# set ap 4 group none
success: change accepted.
set {ap | dap} name
Changes an DWL-8220AP name.
Syntax:
Defaults:
Access:
D-Link Systems, Inc.
Configures a DWL-8220AP group for the DWL-8220AP configuration
template.
DWL-8220AP access point group name of up to 16 alphanumeric
characters, with no spaces.
DWL-8220AP access points are not grouped by default.
Enabled.
You can assign any subset or all of the DWL-8220AP access points connected
to a switch to a group on that switch. All access points in a group must be
connected to the same switch.
If you use the name none, spelled in any combination of capital or lowercase
letters, the specified DWL-8220AP access point is cleared from all
DWL-8220AP access point groups.
The following command configures a DWL-8220AP access point group
named loadbalance1 that contains the DWL-8220AP access points on ports
1, 4, and 6:
set {ap port-list | dap dap-num} name name
The default name of a directly attached DWL-8220AP is based on the port
number of the DWL-8220AP access port attached to the DWL-8220AP. For
example, the default name for an DWL-8220AP on DWL-8220AP access port
1 is AP01. The default name of a Distributed AP is based on the number you
assign to it when you configure the connection. For example, the default name
for Distributed AP 1 is DAP01.
Enabled.
Access Point Commands
171