D-Link DWS-1008 Cli Reference Manual page 24

DWS-1008 CLI Reference Guide
Field
-------------------------------------------------------------------------------------------------------------------------
Temperature
PSU Status
Memory
Total Power Over Ethernet
show tech-support
Provides an in-depth snapshot of the status of the switch, which includes details about the
boot image, the version, ports, and other configuration values. This command also displays
the last 100 log messages.
Syntax: show tech-support [file [subdirname/]filename]
[subdirname/]filename
Defaults: None
Access: Enabled
Usage: Enter this command before calling the D-Link Technical Support.
D-Link Systems, Inc.
Description
Status of temperature sensors at three locations in the
switch:
• ok - Temperature is within the acceptable range of 0° C
to50° C (32° F to 122° F).
• Alarm - Temperature is above or below the acceptable
range. MSS sends an alert to the system log every 5
minutes until this condition is corrected.
Status of the lower and upper power supply units:
• missing - Power supply is not installed or is inoperable.
• DC ok - Power supply is producing DC power.
• DC output failure - Power supply is not producing DC
power. MSS sends an alert to the system log every 5
minutes until this condition is corrected.
• AC ok - Power supply is receiving AC power.
• AC not present - Power supply is not receiving AC
power.
Current size (in megabytes) of nonvolatile memory
(NVRAM) and synchronous dynamic RAM (SDRAM),
plus the percentage of total memory space in use, in the
following format:
NVRAM size /SDRAM size (percent of total)
Total power that the switch is currently supplying to its
directly connected DWL-8220AP access points, in watts.
Optional subdirectory name, and a string up to 32 alphanumeric
characters. The command's output is saved into a file with the
specified name in nonvolatile storage.
System Services Commands
23