Spanning Tree Protocol (Stp) Commands - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Use Spanning Tree Protocol (STP) commands to configure and manage spanning trees
on the virtual LANs (VLANs) configured on a DWS-1008 switch, to maintain a loop-free
network. This chapter presents STP commands alphabetically. Use the following table to
locate commands in this chapter based on their use.
clear spantree portcost
Resets to the default value the cost of a network port or ports on paths to the STP root bridge
in all VLANs on a switch.
Syntax:
port-list
Defaults:
Access:
Usage:
Examples:
DWS-1008# clear spantree portcost 5-6
success: change accepted.
clear spantree portpri
Resets to the default value the priority of a network port or ports for selection as part of the
path to the STP root bridge in all VLANs on a switch.
Syntax:
port-list
Defaults:
Access:
Usage:
D-Link Systems, Inc.
STP Commands
clear spantree portcost port-list
List of ports. The port cost is reset on the
specified ports.
None.
Enabled.
This command resets the cost in all VLANs. To reset the cost for only specific
VLANs, use the clear spantree portvlancost command.
The following command resets the STP port cost on ports 5 and 6 to the
default value:
clear spantree portpri port-list
List of ports. The port priority is reset to 32 (the default) on the
specified ports.
None.
Enabled.
This command resets the priority in all VLANs. To reset the priority for only
specific VLANs, use the clear spantree portvlanpri command.
STP Commands
230