D-Link DWS-1008 Cli Reference Manual page 20
8 port 10/100 wireless switch with power over ethernet
Hide thumbs
Also See for DWS-1008:
- Cli reference manual (531 pages) ,
- Product manual (502 pages) ,
- User manual (454 pages)
Table of Contents
Advertisement
DWS-1008 CLI Reference Guide
set system countrycode (continued)
Defaults: The factory default country code is None.
Access: Enabled.
Usage: You must set the system county code to a valid value before using any set ap com-
mands to configure a DWL-8220AP access point.
Examples: To set the country code to Canada, type the following command:
DWS-1008# set system country code CA
success: change accepted.
set system ip-address
Sets the system IP address so that it can be used by various services in the switch.
Syntax: set system ip-address ip-addr
ip-addr
Defaults: None
Access: Enabled
Examples: The following command sets the IP address of the switch to 192.168.253.1:
DWS-1008# set system ip-address 192.168.253.1
success: change accepted.
D-Link Systems, Inc.
IP address, in dotted decimal notation.
System Services Commands
19
Advertisement
Table of Contents
