D-Link DWS-1008 Cli Reference Manual page 80

DWS-1008 CLI Reference Guide
set snmp notify target (continued)
SNMPv2c with Informs
target-num
ip-addr[:udp-port-number]
community-string
profile profile-name
retries num
timeout num
SNMPv2c with Traps
To configure a notification target for traps from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string trap [profile profile-name]
target-num
ip-addr[:udp-port-number]
community-string
profile profile-name
D-Link Systems, Inc.
ID for the target. This ID is local to the DWS-1008 switch
and does not need to correspond to a value on the target
itself. You can specify a number from 1 to 10.
IP address of the server. You also can specify the UDP
port number to send notifications to.
Community string.
Notification profile this SNMP user will use to specify the
notification types to send or drop.
Specifies the number of times the MSS SNMP engine will
resend a notification that has not been acknowledged by
the target. You can specify from 0 to 3 retries.
Specifies the number of seconds MSS waits for
acknowledgement of a notification. You can specify from
1 to 5 seconds.
ID for the target. This ID is local to the DWS-1008 switch
and does not need to correspond to a value on the target
itself. You can specify a number from 1 to 10.
IP address of the server. You also can specify the UDP
port number to send notifications to.
Community string.
Notification profile this SNMP user will use to specify the
notification types to send or drop.
IP Services Commands
79