DWS-1008 CLI Reference Guide
Examples:
DWS-1008# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
set radio-profile auto-tune power-interval
Sets the interval at which RF Auto-Tuning decides whether to change the power level on
radios in a radio profile. At the end of each interval, MSS processes the results of the RF
scans performed during the previous interval, and changes radio power levels if needed.
Syntax:
name
seconds
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
set radio-profile beacon-interval
Changes the rate at which each DWL-8220AP radio in a radio profile advertises its service
set identifier (SSID).
Syntax:
name
interval
D-Link Systems, Inc.
When RF Auto-Tuning for power is enabled, MSS does not allow you to
manually change the power level.
The following command enables dynamic power tuning for radios in the rp2
radio profile:
set radio-profile name auto-tune power-interval seconds
Radio profile name.
Number of seconds MSS waits before changing radio power levels to adjust
to RF changes, if needed. You can specify from 1 to 65535 seconds.
The default power tuning interval is 300 seconds.
Enabled
RF Auto-Tuning also can temporarily increase a radio's power level to
preserve the minimum data rate for an associated client. In this case, the
radio reduces its power in 1 dBm increments until the power returns to the
expected level.
The following command sets the power interval for radios in radio profile rp2
to 240 seconds:
set radio-profile name beacon-interval interval
Radio profile name.
Number of milliseconds (ms) between beacons. You can specify from 25 ms
to 8191 ms.
Access Point Commands
185