Set Spantree Portfast - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Port Speed
100 Mbps
100 Mbps
100 Mbps
10 Mbps
10 Mbps
10 Mbps
Access: Enabled.
Usage: This command applies only to the default VLAN (VLAN 1). To change the cost
of a port in another VLAN, use the set spantree portvlancost command.
Examples:
DWS-1008# set spantree portcost 3,4 cost 20
success: change accepted.

set spantree portfast

Enables or disables STP port fast convergence on one or more ports on a switch.
Syntax: set spantree portfast port port-list
port port-list
enable
disable
Defaults: STP port fast convergence is disabled by default.
Access: Enabled.
Usage: Use port fast convergence on ports that are directly connected to servers,
hosts, or other MAC stations.
Examples: The following command enables port fast convergence on ports 1, 3, and 6:
DWS-1008# set spantree portfast port 1,3,6 enable
success: change accepted.
D-Link Systems, Inc.
Defaults:
SNMP Port Path Cost
Link Type
Full Duplex Aggregate
Link (Port Group)
Full Duplex
Half Duplex
Full Duplex Aggregate
Link (Port Group)
Full Duplex
Half Duplex
The following command changes the cost on ports 3 and 4 to 20:
List of ports. MSS enables the feature on the
specified ports.
Enables port fast convergence.
Disables port fast convergence.
Default Port Path Cost
19
18
19
19
95
100
enable disable
{ | }
STP Commands
236