D-Link DWS-1008 Cli Reference Manual page 393

DWS-1008 CLI Reference Guide
delete
Removes the currently active boot profile.
Syntax: delete
Defaults: None.
Access: Boot prompt.
Usage: When you type the delete command, the next-lower numbered boot profile becomes
the active profile. For example, if the currently active profile is number 3, profile
number 2 becomes active after you type delete to delete profile 3.You cannot delete
boot profile 0.
Examples: To remove the currently active boot profile, type the following command:
boot> delete
BOOT Index: 1
BOOT TYPE:
DEVICE:
FILENAME:
FLAGS:
OPTIONS:
diag
Accesses the diagnostic mode.
Syntax: diag
Defaults: The diagnostic mode is disabled by default.
Access: Boot prompt.
Usage: Access to the diagnostic mode requires a password, which is not user configurable.
Use this mode only if advised to do so by D-Link.
dir
Displays the boot code and system image files on a DWS-1008 switch.
D-Link Systems, Inc.
c
boot1:
default
00000000
run=nos;boot=0
Boot Prompt Commands
392