D-Link DWS-1008 Cli Reference Manual page 263

DWS-1008 CLI Reference Guide
Type
TTL
Group
Port
Receiver-IP
Receiver-MAC
TTL
Querier information
Querier for vlan
Querier-IP
Querier-MAC
D-Link Systems, Inc.
How the switch learned that the port is a
multicast router port:
• conf - Static multicast port configured
by an administrator
• madv - Multicast advertisement
• quer - IGMP query
• dvmrp - Distance Vector Multicast
Routing Protocol (DVMRP)
• pimv1 - Protocol Independent Multicast
(PIM) version 1
• pimv2 - PIM version 2
Number of seconds before this entry ages
out if not refreshed. For static multicast
router entries, the time-to-live (TTL) value is
undef. Static multicast router entries do not
age out.
IP address of a multicast group. The show
igmp receiver-table command shows the
same information as these receiver fields.
Physical port through which the switch can
reach the group's receiver.
IP address of the client receiving the group.
MAC address of the client receiving the
group.
Number of seconds before this entry ages
out if the switch does not receive a group
membership message from the receiver.
For static multicast receiver entries, the
TTL value is undef. Static multicast receiver
entries do not age out.
Information about the subnet's multicast
querier. If the querier is another device,
the fields described below are applicable.
If the querier is the switch itself, the output
indicates how many seconds remain until
the next general query message. If IGMP
snooping does not detect a querier, the
output indicates this. The show igmp
querier command shows the same
information.
VLAN containing the querier. Information is
listed separately for each VLAN.
IP address of the querier.
MAC address of the querier.
IGMP Snooping Commands
262