D-Link DWS-1008 Cli Reference Manual page 188

DWS-1008 CLI Reference Guide
set radio-profile dtim-interval
Changes the number of times after every beacon that each DWL-8220AP radio in a radio
profile sends a delivery traffic indication map (DTIM). An DWL-8220AP access point sends
the multicast and broadcast frames stored in its buffers to clients who request them in
response to the DTIM.
Note: The DTIM interval applies to both the beaconed SSID and the nonbeaconed SSID.
Syntax:
name
interval
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp1 dtim-interval 2
success: change accepted.
set radio-profile frag-threshold
Changes the fragmentation threshold for the DWL-8220AP radios in a radio profile. The
fragmentation threshold specifies the maximum length a frame is allowed to be without being
broken into multiple frames before transmission.
Syntax:
name
threshold
Defaults:
Access:
D-Link Systems, Inc.
set radio-profile name dtim-interval interval
Radio profile name.
Number of times the DTIM is transmitted after every beacon. You can enter a
value from 1 through 31.
By default, DWL-8220AP access points send the DTIM once after each
beacon.
Enabled
You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command.
The DTIM interval does not apply to unicast frames.
The following command changes the DTIM interval for radio profile rp1 to 2:
set radio-profile name frag-threshold threshold
Radio profile name.
Maximum frame length, in bytes. You can enter a value from 256 through
2346.
The default fragmentation threshold for DWL-8220AP radios is 2346 bytes.
Enabled.
Access Point Commands
187