D-Link DWS-1008 Cli Reference Manual page 242

DWS-1008 CLI Reference Guide
Field
VLAN
Spanning tree mode In the current software version, the mode
Spanning tree type
Spanning tree
enabled
Designated Root
Designated Root
Priority
Designated Root
Path Cost
Designated Root
Port
Root Max Age
Root Hello Time
Root Forward Delay
Bridge ID MAC
ADDR
Bridge ID Priority
Bridge Max Age
Bridge Hello Time
Bridge Forward
Delay
Port
Vlan
D-Link Systems, Inc.
Output for show spantree
Description
VLAN number.
is always PVST+, which means Per VLAN
Spanning Tree+.
In the current software version, the type is
always IEEE, which means STP is based on
the IEEE 802 standards.
State of STP on the VLAN.
MAC address of the spanning tree's root
bridge.
Bridge priority of the root bridge.
Cumulative cost from this bridge to the root
bridge. If this switch is the root bridge, then the
root cost is 0.
Port through which this switch reaches the
root bridge.
If this switch is the root bridge, this field says
We are the root.
Maximum acceptable age for hello packets on
the root bridge.
Hello interval on the root bridge.
Forwarding delay value on the root bridge.
This switch's MAC address.
This switch's bridge priority.
This switch's maximum acceptable age for
hello packets.
This switch's hello interval.
This switch's forwarding delay value.
Port number.
Note: Only network ports are listed. STP does not
apply to DWL-8200AP access point ports or wired
authentication ports.
VLAN ID.
STP Commands
241