Set Igmp Lmqi; Set Igmp Mrouter - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
DWS-1008# set igmp disable vlan orange
success: change accepted.

set igmp lmqi

Changes the IGMP last member query interval timer on one VLAN or all VLANs on a
switch.
Syntax: set igmp lmqi tenth-seconds [vlan vlan-id]
lmqi
tenth-seconds
vlan vlan-id
Defaults: The default last member query interval is 10 tenths of a second (1 second).
Access: Enabled.
Examples: The following command changes the last member query interval on VLAN
DWS-1008# set igmp lmqi 5 vlan orange
success: change accepted.

set igmp mrouter

Adds or removes a port in a switch's list of ports on which it forwards traffic to multicast
routers. Static multicast ports are immediately added to or removed from the list of router
ports and do not age out.
Syntax: set igmp mrouter port port-list {enable | disable}
port port-list Port list. MSS adds or removes the specified ports
D-Link Systems, Inc.
Amount of time (in tenths of a second)
that the switch waits for a response to a
group-specific query after receiving a leave
message for that group, before removing the
receiver that sent the leave message from
the list of receivers for the group. If there are
no more receivers for the group, the switch
also sends a leave message for the group
to multicast routers. You can specify a value
from 1 through 65,535.
VLAN name or number. If you do not specify
a VLAN, the timer change applies to all
VLANs.
orange to 5 tenths of a second:
in the list of static multicast router ports.
IGMP Snooping Commands
253