D-Link DWS-1008 Cli Reference Manual page 166

DWS-1008 CLI Reference Guide
The following commands disable the radios that are using radio profile rptest and remove
the profile:
DWS-1008# set radio-profile rptest mode disable
DWS-1008# clear radio-profile rptest
success: change accepted.
clear service-profile
Removes a service profile or resets one of the profile's parameters to its default value.
Syntax:
name
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp6 mode disable
DWS-1008# clear radio-profile rp6 service-profile svcprof6
success: change accepted.
DWS-1008# clear service-profile svcprof6
success: change accepted.
reset {ap | dap}
Restarts a DWL-8220AP access point.
Syntax:
ap port-list
dap dap-num
Defaults:
Access:
D-Link Systems, Inc.
clear service-profile name
Service profile name.
None
Enabled
If the service profile is mapped to a radio profile, you must remove it from the
radio profile first. (After disabling all radios that use the radio profile, use the
clear radio-profile name service-profile name command.)
The following commands disable the radios that are using radio profile rp6,
remove service-profile svcprof6 from rp6, then clear svcprof6 from the configuration.
reset {ap port-list | dap dap-num}
List of ports connected to the DWL-8220AP access points to restart.
Number of a Distributed AP to reset.
None
Enabled.
Access Point Commands
165