D-Link DWS-1008 Cli Reference Manual page 226

DWS-1008 CLI Reference Guide
show radio-profile
Displays radio profile information.
Syntax:
name
Defaults:
Access:
Usage:
Examples:
DWS-1008# show radio-profile default
Beacon Interval:
Max Tx Lifetime:
RTS Threshold:
Short Retry Limit:
Long Preamble:
Tune Channel:
Tune Channel Interval:
Power Backoff Timer:
Countermeasures:
WMM enabled:
Service profiles: default-dot1x, default-clear
The table below describes the fields in this display.
Field
-----------------------------------------------------------------------------------------------------------------------
Beacon Interval
-----------------------------------------------------------------------------------------------------------------------
DTIM Interval
-----------------------------------------------------------------------------------------------------------------------
Max Tx Lifetime
-----------------------------------------------------------------------------------------------------------------------
Max Rx Lifetime
D-Link Systems, Inc.
show radio-profile {name | ?}
Displays information about the named radio profile. ? Displays a list of radio
profiles.
None.
Enabled.
MSS contains a default radio profile. D-Link recommends that you do not
change this profile but instead keep the profile for reference.
The following command shows radio profile information for the default radio
profile:
100
2000
2346
5
NO
no
3600
10
none
yes
Description
Rate (in milliseconds) at which each DWL-8220AP radio in the
profile advertises the beaconed SSID.
Number of times after every beacon that each DWL-8220AP radio in
the radio profile sends a delivery traffic indication map (DTIM).
Number of milliseconds that a frame received by a radio in the radio
profile can remain in buffer memory.
Number of milliseconds that a frame scheduled to be transmitted by
a radio in the radio profile can remain in buffer memory.
DTIM Interval:
Max Rx Lifetime:
Frag Threshold:
Long Retry Limit:
Allow 802.11g clients only:
Tune Power:
Tune Power Interval:
Channel Holddown:
Active-Scan:
Access Point Commands
1
2000
2346
5
NO
no
600
300
yes
225