D-Link DWS-1008 Cli Reference Manual page 291

DWS-1008 CLI Reference Guide
3. When MSS prompts you for the PEM-formatted certificate, paste the PKCS #7
object file onto the command line.
Examples: The following command adds the certificate authority's certificate to certificate
DWS-1008# crypto ca-certificate admin
Enter PEM-encoded certificate
-----BEGIN CERTIFICATE-----
MIIDwDCCA2qgAwIBAgIQL2jvuu4PO5FAQCyewU3ojANBgkqhkiG9wOBAQUFADCB
mzerMClaweVQQTTooewi\wpoer0QWNFNkj90044mbdrl1277SWQ8G7DiwYUtrqoQplKJvx
z .....
Lm8wmVYxP56M;CUAm908C2foYgOY40=
-----END CERTIFICATE-----
crypto certificate
Installs one of the switch's PKCS #7 certificates into the certificate and key storage area on
the switch. The certificate, which is issued and signed by a certificate authority, authenticates
the switch to Web View, or to 802.1X supplicants (clients).
Syntax: crypto certificate {eap} PEM-formatted certificate
eap
PEM-formatted
certificate
Defaults: None
Usage: To use this command, you must already have generated a certificate request with
the crypto generate request command, sent the request to the certificate authority,
and obtained a signed copy of the switch certificate as a PKCS #7 object file. Then
do the following:
1. Open the PKCS #7 object file with an ASCII text editor such as Notepad or vi.
2. Enter the crypto certificate command on the CLI command line.
3. When MSS prompts you for the PEM-formatted certificate, paste the PKCS #7
object file onto the command line.
D-Link Systems, Inc.
and key storage:
Stores the certificate authority's Extensible Authentication Protocol
(EAP) certificate, which authenticates the switch to 802.1X
supplicants (clients).
ASCII text representation of the PKCS #7 certificate, consisting of up
to 4096 characters, that you have obtained from the certificate
authority.
Access: Enabled
Cryptography Commands
290