Set Server Group - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

set server group

Configures a group of one to four RADIUS servers.
Syntax:
name3] [server-name4]
group-name
members
server-name1
server-name2
server-name3
server-name4
Defaults:
Access:
Usage:
Do not use the same name for a RADIUS server and a RADIUS server group.
Examples:
DWS-1008# set server group shorebirds members heron egret sandpiper
success: change accepted.
set server group load-balance
Enables or disables load balancing among the RADIUS servers in a server group.
Syntax:
group-name
load-balance
enable | disable
D-Link Systems, Inc.
set server group group-name members server-name1 [server-name2] [server-
Server group name of up to 32 characters, with
no spaces or tabs.
The names of one or more configured RADIUS
servers. You can enter up to four server names.
None.
Enabled.
You must assign all group members simultaneously, as shown in the
example. To enable load balancing, use set server group load-balance
enable.
To set server group shorebirds with members heron, egret, and sandpiper,
type the following command:
set server group group-name load-balance {enable | disable}
Server group name of up to 32 characters.
Enables or disables load balancing of
authentication requests among the servers in the
group.
RADIUS Commands
309