Set Igmp Mrsol - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
enable
disable
Defaults: By default, no ports are static multicast router ports.
Access: Enabled.
Usage: You cannot add DWL-8200AP access ports or wired authentication ports as
static multicast ports. However, MSS can dynamically add these port types to
the list of multicast ports based on multicast traffic.
Examples: The following command adds port 9 as a static multicast router port:
DWS-1008# set igmp mrouter port 9 enable
success: change accepted.
The following command removes port 9 from the static multicast router port list:
DWS-1008# set igmp mrouter port 9 disable
success: change accepted.

set igmp mrsol

Enables or disables multicast router solicitation by a switch on one VLAN or all VLANs.
Syntax: set igmp mrsol {enable | disable} [vlan vlan-id]
enable
disable
vlan vlan-id VLAN name or number. If you do not specify a
Defaults: Multicast router solicitation is disabled on all VLANs by default.
Access: Enabled.
Examples: The following command enables multicast router solicitation on VLAN orange:
DWS-1008# set igmp mrsol enable vlan orange
success: change accepted.
D-Link Systems, Inc.
Adds the port to the list of static multicast router
ports.
Removes the port from the list of static multicast
router ports.
Enables multicast router solicitation.
Disables multicast router solicitation.
VLAN, multicast router solicitation is disabled or
enabled on all VLANs.
IGMP Snooping Commands
254