D-Link DWS-1008 Cli Reference Manual page 183

DWS-1008 CLI Reference Guide
Usage:
Examples:
DWS-1008# set radio-profile radprof3 active-scan disable
success: change accepted.
set radio-profile auto-tune channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the DWL-8220AP
radios in a radio profile.
Syntax:
name
enable
disable
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp2 auto-tune channel-config disable
success: change accepted.
set radio-profile auto-tune channel-holddown
Sets the minimum number of seconds a radio in a radio profile must remain at its current
channel assignment before RF Auto-Tuning can change the channel. The channel holddown
provides additional stability to the network by preventing the radio from changing channels too
rapidly in response to spurious RF anomalies such as short-duration channel interference.
Syntax
name
D-Link Systems, Inc.
You can enter this command on any DWS-1008 switch. The command takes
effect only on that switch.
The following command disables active scan in radio profile radprof3:
set radio-profile name auto-tune channel-config {enable | disable}
Radio profile name.
Configures radios to dynamically select their channels when the radios are
started.
Configures radios to use their statically assigned channels, or the default
channels if unassigned, when the radios are started.
Dynamic channel assignment is enabled by default.
Enabled.
If you disable RF Auto-Tuning for channels, MSS does not dynamically set
the channels when radios are first enabled and also does not tune the channels
during operation.
If RF Auto-Tuning for channels is enabled, MSS does not allow you to
manually change channels.
The following command disables dynamic channel tuning for radios in the rp2
radio profile:
set radio-profile name auto-tune channel-holddown holddown
Radio profile name.
Access Point Commands
182