DWS-1008 CLI Reference Guide
set spantree fwddelay
Changes the period of time after a topology change that a switch which is not the root bridge
waits to begin forwarding Layer 2 traffic on one or all of its configured VLANs. (The root
bridge always forwards traffic.)
Syntax:
delay
all
vlan vlan-id VLAN name or number. MSS changes the
Defaults: The default forwarding delay is 15 seconds.
Access: Enabled.
Examples: The following command changes the forwarding delay on VLAN pink to
DWS-1008# set spantree fwddelay 20 vlan pink
success: change accepted.
set spantree hello
Changes the interval between STP hello messages sent by a switch when operating as the
root bridge, on one or all of its configured VLANs.
Syntax: set spantree hello interval {all | vlan vlan-id}
interval
all
vlan vlan-id VLAN name or number. MSS changes the
Defaults: The default hello timer interval is 2 seconds.
Access: Enabled.
Examples: The following command changes the hello interval for all VLANs to 4 seconds:
D-Link Systems, Inc.
set spantree fwddelay delay {all | vlan vlan-id}
Delay value. You can specify from 4 through 30
seconds.
Changes the forwarding delay on all VLANs.
forwarding delay on only the specified VLAN.
20 seconds:
Interval value. You can specify from 1 through 10
seconds.
Changes the interval on all VLANs.
interval on only the specified VLAN.
STP Commands
234