D-Link DWS-1008 Cli Reference Manual page 179

DWS-1008 CLI Reference Guide
mode enable
mode disable
Defaults: None
Usage:
Examples:
DWS-1008# set ap 4-6 radio 1 radio-profile rp1 mode enable
success: change accepted.
set {ap | dap} radio tx-power
Sets an DWL-8220AP radio's transmit power.
Syntax:
ap port-list
dap dap-num
radio 1
radio 2
tx-power
Defaults:
D-Link Systems, Inc.
Enables radios on the specified ports with the parameter
settings in the specified radio profile.
Disables radios on the specified ports.
Access: Enabled
When you create a new profile, the radio parameters in the profile are set to
their factory default values. To enable or disable all radios that use a specific
radio profile, use set radio-profile.
The following command enables radio 1 on ports 4 through 6 assigned to
radio profile rp1:
set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level
List of ports connected to the DWL-8220AP access points on which to
set the transmit power.
Number of a Distributed AP on which to set the transmit power.
Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
Number of decibels in relation to 1 milliwatt (dBm). The power-level
valid values depend on the country of operation.
Note: The maximum transmit power you can configure on any D-Link
radio is the maximum allowed for the country in which you plan
to operate the radio or one of the following values if that value is less
than the country maximum: on an 802.11a radio, 11 dBm for channel
numbers less than or equal to 64, or 10 dBm for channel numbers
greater than 64; on an 802.11b/g radio, 16 dBm for all valid channel
numbers for 802.11b, or 14 dBm for all valid channel numbers for
802.11g.
The default transmit power on all DWL-8220AP radio types is the highest
setting allowed for the country of operation or highest setting supported on
the hardware, whichever is lower.
Access Point Commands
178