Show Igmp - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Access: Enabled.
Usage: You cannot add DWL-8200AP access ports or wired authentication ports as
static multicast ports. However, MSS can dynamically add these port types to
the list of multicast ports based on multicast traffic.
Examples: The following command adds port 7 as a static multicast receiver port:
DWS-1008# set igmp receiver port 7 enable
success: change accepted.
The following command removes port 7 from the list of static multicast receiver ports:
DWS-1008# set igmp receiver port 7 disable
success: change accepted.
set igmp rv
Changes the robustness value for one VLAN or all VLANs on a switch. Robustness adjusts
the IGMP timers to the amount of traffic loss that occurs on the network.
Syntax: set igmp rv num
num
vlan vlan-id VLAN name or number. If you do not specify a
Defaults: The default robustness value for all VLANs is 2.
Access: Enabled.
Examples: The following example changes the robustness value on VLAN orange to 4:
DWS-1008# set igmp rv 4 vlan orange
success: change accepted.

show igmp

Displays IGMP configuration information and statistics for one VLAN or all VLANs.
D-Link Systems, Inc.
vlan vlan-id
[
Robustness value. You can specify a value from
2 through 255. Set the robustness value higher to
adjust for more traffic loss.
VLAN, MSS changes the robustness value for all
VLANs.
]
IGMP Snooping Commands
259