Set Igmp Mrsol Mrsi; Set Igmp Oqi - D-Link DWS-1008 Cli Reference Manual
8 port 10/100 wireless switch with power over ethernet
Hide thumbs
Also See for DWS-1008:
- Cli reference manual (531 pages) ,
- Product manual (502 pages) ,
- User manual (454 pages)
Table of Contents
Advertisement
DWS-1008 CLI Reference Guide
set igmp mrsol mrsi
Changes the interval between multicast router solicitations by a switch on one VLAN or all
VLANs.
Syntax: set igmp mrsol mrsi seconds [vlan vlan-id]
seconds
vlan vlan-id VLAN name or number. If you do not specify
Defaults: The interval between multicast router solicitations is 30 seconds by default.
Access: Enabled.
Examples: The following example changes the multicast router solicitation interval to 60
DWS-1008# set igmp mrsol mrsi 60
success: change accepted.
set igmp oqi
Changes the IGMP other-querier-present interval timer on one VLAN or all VLANs on a
switch.
Syntax: set igmp oqi seconds [vlan vlan-id]
oqi seconds Number of seconds that the switch waits for a
vlan vlan-id VLAN name or number. If you do not specify a
Defaults: The default other-querier-present interval is 255 seconds (4.25 minutes).
Access: Enabled.
Usage: A switch cannot become the querier unless the pseudo-querier feature
is enabled on the switch. When the feature is enabled, the switch becomes
the querier for a subnet so long as the switch does not receive a query
message from a router with a lower IP address than the IP address of the switch
in that subnet. To enable the pseudo-querier feature, use set igmp querier.
D-Link Systems, Inc.
Number of seconds between multicast router
solicitations. You can specify a value from 1
through 65,535.
a VLAN, MSS changes the multicast router
solicitation interval for all VLANs.
seconds:
general query to arrive before electing itself the
querier. You can specify a value from 1 through
65,535.
VLAN, the timer change applies to all VLANs.
IGMP Snooping Commands
255
Advertisement
Table of Contents
