D-Link DWS-1008 Cli Reference Manual page 318

DWS-1008 CLI Reference Guide
set dot1x port-control
Determines the 802.1X authentication behavior on individual wired authentication ports or
groups of ports.
Syntax:
forceauth
forceunauth Forces the specified wired authentication port(s)
auto
port-list
Defaults:
Access:
Usage:
Examples:
DWS-1008# set dot1x port-control forceauth 19
success: authcontrol for 19 is set to FORCE-AUTH.
set dot1x quiet-period
Sets the number of seconds a DWS-1008 switch remains quiet and does not respond to a
supplicant after a failed authentication.
Syntax:
seconds
Defaults:
Access:
D-Link Systems, Inc.
set dot1x port-control {forceauth | forceunauth | auto} port-list
Forces the specified wired authentication
port(s) to unconditionally authorize all 802.1X
authentication attempts, with an EAP success
message.
to unconditionally reject all 802.1X authentication
attempts with an EAP failure message.
Allows the specified wired authentication
ports to process 802.1X authentication
normally as determined for the user by the set
authentication dot1X command.
One or more wired authentication ports for which
to set 802.1X port control.
By default, wired authentication ports are set to auto.
Enabled.
This command affects only wired authentication ports.
The following command forces port 19 to unconditionally accept all 802.1X
authentication attempts:
set dot1x quiet-period seconds
Specify a value between 0 and 65,535.
The default is 60 seconds.
Enabled.
802.1x Management Commands
317