D-Link DWS-1008 Cli Reference Manual page 199

DWS-1008 CLI Reference Guide
Examples:
DWS-1008# set service-profile sp2 cipher-wep104 enable success: change accepted.
set service-profile cipher-wep40
Enables dynamic Wired Equivalent Privacy (WEP) with 40-bit keys, in a service profile.
Syntax:
name
disable
Defaults:
Access:
Usage:
Examples:
DWS-1008# set service-profile sp2 cipher-wep40 enable
success: change accepted.
D-Link Systems, Inc.
The following command configures service profile sp2 to use 104-bit WEP
encryption:
set service-profile name cipher-wep40 {enable | disable}
Service profile name. enable Enables 40-bit WEP encryption for WPA clients.
Disables 40-bit WEP encryption for WPA clients.
40-bit WEP encryption is disabled by default.
Enabled
To use 40-bit WEP with WPA clients, you must also enable the WPA IE. When
40-bit WEP in WPA is enabled in the service profile, radios managed by a
radio profile that is mapped to the service profile can also support non-WPA
clients that use dynamic WEP.
To support WPA clients that use 104-bit dynamic WEP, you must enable
WEP with 104-bit keys in the service profile. Use the set service-profile
cipher-wep104 command.
Microsoft Windows XP does not support WEP with WPA. To configure a
service profile to provide dynamic WEP for XP clients, leave WPA disabled
and use the set service-profile wep commands.
To support non-WPA clients that use static WEP, you must configure static
WEP keys. Use the set service-profile wep key-index command.
The following command configures service profile sp2 to use 40-bit WEP
encryption:
Access Point Commands
198