D-Link DWS-1008 Cli Reference Manual page 78

DWS-1008 CLI Reference Guide
set snmp notify target (continued)
target-num
ip-addr
[:udp-port-number]
username
snmp-engine-id
{ip | hex hex-string}
profile profile-name
security {unsecured |
authenticated
| encrypted}
retries num
timeout num
D-Link Systems, Inc.
IDforthetarget.ThisIDislocaltotheDWS-1008switchanddoesnot
need to correspond to a value on the target itself.You can specify a
number from 1 to 10.
IP address of the server. You also can specify the UDP port
number to send notifications to.
USM username. This option is applicable only when the SNMP
version is usm. If the user will send informs rather than traps, you
also must specify the snmp-engine-id of the target.
SNMP engine ID of the target. Specify ip if the target's SNMP
engine ID is based on its IP address. If the target's SNMP engine
ID is a hexadecimal value, use hex hex-string to specify the
value.
Notification profile this SNMP user will use to specify the
notification types to send or drop.
Specifies the security level, and is applicable only when the
SNMP version is usm:
• unsecured - Message exchanges are not
authenticated, nor are they encrypted. This is the default.
• authenticated - Message exchanges are authenticated, but
are not encrypted.
• encrypted - Message exchanges are authenticated and
encrypted.
Specifies the number of times the MSS SNMP engine will resend
a notification that has not been acknowledged by the target. You
can specify from 0 to 3 retries.
Specifies the number of seconds MSS waits for acknowledgemen
of a notification. You can specify from 1 to 5 seconds.
IP Services Commands
77