Set Spantree Maxage; Set Spantree Portcost - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
DWS-1008# set spantree hello 4 all
success: change accepted.

set spantree maxage

Changes the maximum age for an STP root bridge hello packet that is acceptable to a switch
acting as a designated bridge on one or all of its VLANs. After waiting this period of time for
a new hello packet, the switch determines that the root bridge is unavailable and issues a
topology change message.
Syntax:
aging-time
all
vlan vlan-id
Defaults: The default maximum age for root bridge hello packets is 20 seconds.
Access: Enabled.
Examples: The following command changes the maximum acceptable age for root
DWS-1008# set spantree maxage 15 all
success: change accepted.

set spantree portcost

Changes the cost that transmission through a network port or ports in the default VLAN on a
switch adds to the total cost of a path to the STP root bridge.
Syntax: set spantree portcost port-list cost cost
port-list
cost cost
Defaults: The default port cost depends on the port speed and link type. SNMP Port
Path Cost Defaults: lists the defaults for STP port path cost.
D-Link Systems, Inc.
set spantree maxage aging-time
Maximum age value. You can specify from 6
through 40 seconds.
Changes the maximum age on all VLANs.
VLAN name or number. MSS changes the
maximum age on only the specified VLAN.
bridge hello packets on all VLANs to 15 seconds:
List of ports. MSS applies the cost change to all
the specified ports.
Numeric value. You can specify a value from 1
through 65,535. STP selects lower-cost paths
over higher-cost paths.
all vlan vlan-id
{ | }
STP Commands
235