Set Log Trace Mbytes - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
local-facility
facility-level
enable
disable
Defaults:
• Events at the error level and higher are logged to the switch console.
• Events at the error level and higher are logged to the switch system buffer.
• Trace logging is enabled, and debug-level output is stored in the switch trace buffer.
Access: Enabled.
Usage: Using the command with only enable or disable turns logging on or off for the
target at all levels. For example, entering set log buffer enable with no other
keywords turns on logging to the system buffer of all facilities at all levels. Entering
set log buffer disable with no other keywords turns off all logging to the buffer.
Examples: To log only emergency, alert, and critical system events to the console, type the
following command:
DWS-1008# set log console severity critical enable
success: change accepted.

set log trace mbytes

Changes the size of trace log files.
D-Link Systems, Inc.
For messages sent to a syslog server, maps all messages
of the severity you specify to one of the standard local log
facilities defined in RFC 3164. You can specify one of the
following values:
• 0 - maps all messages to local0.
• 1 - maps all messages to local1.
• 2 - maps all messages to local2.
• 3 - maps all messages to local3.
• 4 - maps all messages to local4.
• 5 - maps all messages to local5.
• 6 - maps all messages to local6.
• 7 - maps all messages to local7.
If you do not specify a local facility, MSS sends the
messages with their default MSS facilities. For example,
AAA messages are sent with facility 4 and boot messages
are sent with facility 20 by default.
Enables messages to the specified target.
Disables messages to the specified target.
System Log Commands
382