D-Link DWS-1008 Cli Reference Manual page 79

DWS-1008 CLI Reference Guide
set snmp notify target (continued)
SNMPv3 with Traps
To configure a notification target for traps from SNMPv3, use the following command:
Syntax: set snmp notify target target-num ip-addr[:udp-port-number]
usm trap user username [profile profile-name]
[security {unsecured | authenticated | encrypted}]
target-num
ip-addr[:udp-port-number]
username
profile profile-name
security {unsecured |
authenticated | encrypted}
SNMPv2c with Informs
To configure a notification target for informs from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string inform [profile profile-name] [retries num] [timeout num]
D-Link Systems, Inc.
ID for the target. This ID is local to the DWS-1008 switch
and does not need to correspond to a value on the target
itself. You can specify a number from 1 to 10.
IP address of the server. You also can specify the UDP
port number to send notifications to.
USM username. This option is applicable only when the
SNMP version is usm.
Notification profile this SNMP user will use to specify the
notification types to send or drop.
Specifies the security level, and is applicable only when
the SNMP version is usm:
• unsecured - Message exchanges are not authenticated,
nor are they encrypted. This is the default.
• authenticated - Message exchanges are authenticated,
but are not encrypted.
• encrypted - Message exchanges are authenticated and
encrypted.
IP Services Commands
78