D-Link DWS-1008 Cli Reference Manual page 189

DWS-1008 CLI Reference Guide
Usage:
Examples:
DWS-1008# set radio-profile rp1 frag-threshold 1500
success: change accepted.
set radio-profile long-retry
Changes the long retry threshold for the DWL-8220AP radios in a radio profile. The long
retry threshold specifies the number of times a radio can send a long unicast frame without
receiving an acknowledgment. A long unicast frame is a frame that is equal to or longer than
the Request-to-Send (RTS) threshold.
Syntax:
name
threshold
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp1 long-retry 8
success: change accepted.
set radio-profile max-rx-lifetime
Changes the maximum receive threshold for the DWL-8220AP radios in a radio profile. The
maximum receive threshold specifies the number of milliseconds that a frame received by a
radio can remain in buffer memory.
Syntax:
name
time
Defaults:
D-Link Systems, Inc.
You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command.
The following command changes the fragmentation threshold for radio profile
rp1 to 1500 bytes:
set radio-profile name long-retry threshold
Radio profile name.
Number of times the radio can send the same long unicast frame. You can
enter a value from 1 through 15.
The default long unicast retry threshold for DWL-8220AP radios is 5 attempts.
Enabled
You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command.
The following command changes the long retry threshold for radio profile rp1 to 8:
set radio-profile name max-rx-lifetime time
Radio profile name.
Number of milliseconds. You can enter a value from 500 (0.5 second)
through 250,000 (250 seconds).
The default maximum receive threshold for DWL-8220AP radios is 2000ms.
Access Point Commands
188