D-Link DWS-1008 Cli Reference Manual page 391

DWS-1008 CLI Reference Guide
Examples: The following command loads system image file 010101.020 from boot
boot> boot FN=010101.020 DEV=boot1
Compact Flash load from boot1:testcfg matches 010101.020.
unzip: Inflating ramdisk_1.1.1.. OK
unzip file len 36085486 OK
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Power Cycle Reboot
Detecting hardware...done.
readclock: 2003-10-8 2:9:50.67 UTC=>1065578990.670000 (1064992894)
init: Creating mfs /dev
erase ^H, werase ^W, kill ^U, intr ^C, status ^T
Doing D-Link mounts and links
Starting nos_mon...
nos_mon:ps: not found
SYSLOGD Oct 08 02:10:05.477814 CRITICAL SYSTEM_READY: The system has finished
booting.
Copyright (c) 2002, 2003
D-link Systems, Inc.
Username:
Password:
change
Changes parameters in the currently active boot profile. change
Defaults: The default boot type is c (compact flash). The default filename is default. The
Access: Boot prompt.
Usage: After you type the change command, the system interactively displays the current
setting of each parameter and prompts you for the new setting. When prompted,
type the new setting, press Enter to accept the current setting, or type . (period) to
change the setting to its default value. To back up to the previous parameter, type
- (hyphen).
D-Link Systems, Inc.
partition 1:
default flags setting is 0x00000000 (all flags disabled) and the default options list
is run=nos;boot=0. The default device setting is the boot partition specified by the
most recent set boot partition command typed at the Enabled level of the CLI, or
boot 0 if the command has never been typed.
Boot Prompt Commands
390