D-Link DWS-1008 Cli Reference Manual page 360

DWS-1008 CLI Reference Guide
DWS-1008# reset system
This will reset the entire system. Are you sure (y/n)y
The following commands attempt to restart a switch with a running configuration that has
unsaved changes, and then force the switch to restart:
DWS-1008# reset system
error: Cannot reset, due to unsaved configuration changes. Use "reset system force" to
override.
DWS-1008# reset system force
...... rebooting ......
restore
Unzips a system archive created by the backup command and copies the files from the
archive onto the switch.
Syntax: restore system [tftp:/ip-addr/]filename [all | critical] [force]
[tftp:/ip-addr/]filename
all
critical
force
Defaults: The default is critical.
Access: Enabled.
Usage: If a file in the archive has a counterpart on the switch, the archive version of the
file replaces the file on the switch. The restore command does not delete files
that do not have counterparts in the archive. For example, the command does not
completely replace the user files area. Instead, files in the archive are added to the
user files area. A file in the user area is replaced only if the archive contains a file
with the same name.
D-Link Systems, Inc.
Name of the archive file to load. The
archive can be located in the switch's
nonvolatile storage or on a TFTP
server.
Restores system files and the user
files from the archive.
Restores system files only, including
the configuration file used when
booting, and certificate files.
Replaces files on the switch with those
in the archive, even if the switch is not
the same as the one from which the
archive was created.
CAUTION: Do not use this option
unless advised to do so by D-Link Tech
Support. If you restore one switch's
system files onto another switch, you
must generate new key pairs and
certificates on the switch.
File Management Commands
359