Set Rfdetect Signature - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

set rfdetect signature

Enables AP signatures. An AP signature is a set of bits in a management frame sent by an
AP that identifies that AP to MSS. If someone attempts to spoof management packets from
a D-link AP, MSS can detect the spoof attempt.
Syntax: set rfdetect signature {enable | disable}
enable
disable
Defaults: AP signatures are disabled by default.
Access: Enabled.
Usage:
Examples: The following command enables AP signatures on an DWS-1008 switch:
DWS-1008# set rfdetect signature enable
success: signature is now enabled.
set rfdetect ssid-list
Adds an SSID to the permitted SSID list.The permitted SSID list specifies the SSIDs that are
allowed on the network. If MSS detects packets for an SSID that is not on the list, the AP that
sent the packets is classified as a rogue. MSS issues countermeasures against the rogue if
they are enabled.
Syntax: set rfdetect ssid-list ssid-name
ssid-name
Defaults: The permitted SSID list is empty by default and all SSIDs are allowed.
Access: Enabled.
Usage: The permitted SSID list applies only to the switch on which the list is configured.
Switches do not share permitted SSID lists.
Examples: The following command adds SSID mycorp to the list of permitted SSIDs:
DWS-1008# set rfdetect ssid-list mycorp
success: ssid mycorp is now in ssid-list.
set rfdetect vendor-list
Adds an entry to the permitted vendor list. The permitted vendor list specifies the third-party
D-Link Systems, Inc.
Enables AP signatures.
Disables AP signatures.
The command applies only to APs managed by the switch on which you enter
the command.
SSID name you want to add to the permitted
SSID list.
However, after you add an entry to the list, MSS allows traffic only for the SSIDs
that are on the list.
RF Detection Commands
340