D-Link DWS-1008 Cli Reference Manual page 396

DWS-1008 CLI Reference Guide
ls
Displays a list of the boot prompt commands.
Syntax: ls
Defaults: None.
Access: Boot prompt.
Usage: To display help for an individual command, type help followed by the command name
(for example, help boot).
Examples: To display a list of the commands available at the boot prompt, type the
boot> ls
ls
help
autoboot Display the state of, enable, or disable the autoboot option.
boot
change Change the current boot configuration profile.
create
delete
next
show
dir
fver
version
reset
test
diag
next
Activates and displays the boot profile in the next boot profile slot.
Syntax: next
Defaults: None.
Access: Boot prompt.
Usage: A DWS-1008 switch contains 4 boot profile slots, numbered 0 through 3. This
command activates the boot profile in the next slot, in ascending numerical order. If
the currently active slot is 3, the command activates the boot profile in slot 0.
D-Link Systems, Inc.
following command:
Display a list of all commands and descriptions.
Display help information for each command.
Load and execute an image using the current boot configuration profile.
Create a new boot configuration profile.
Delete the current boot configuration profile.
Select the next boot configuration profile.
Display the current boot configuration profile.
Display the contents of the specified boot partition.
Display the version of the loadable image specified by device:filename.
Display HW and Bootstrap/Bootloader version information.
Reset the system.
Display the state of, enable, or disable the tests option.
Access the diagnostic command CLI.
Boot Prompt Commands
395