Clear Counters - D-Link DES-7200 Cli Reference Manual

Hide thumbs Also See for DES-7200:

Table of Contents

DES-7200 CLI Reference Guide

clear counters

Use this command to clear the counters on the specified interface.

clear counters [interface-id]

Interface configuration mode

This parameter refers to the delay after which the carrier detection

signal DCD of the interface link changes from the Down status to the

Up status. If the DCD changes within the delay, the system will ignore

such changes without disconnecting the upeer data link layer for

renegotiation.

If the DCD carrier is disconnected for a long time, the parameter

should be set longer to accelerate route aggregation so that the

routing table can be converged more quickly. On the contrary, if the

DCD carrier interruption period is shorter than the time used for route

aggregation, you should set the parameter to a higher value to avoid

unnecessary route vibration.

The following example shows how to configure the carrier delay of

serial interface to 5 seconds:

DES-7210(config)# interface gigabitethernet 1/1

DES-7210(config)# carrier-delay 5

interface-id

Interface type and interface ID

Privileged mode.

In the privileged EXEC mode, use the show interfaces command to

display the counters or the clear counters command to clear the

counters. If the interface is not specified, the counters on all

interfaces will be cleared.

DES-7210# clear counters gigabitethernet 1/1

Chapter 6 Interface Configuration Commands