D-Link DWS-1008 Cli Reference Manual page 187

DWS-1008 CLI Reference Guide
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp1 beacon-interval 200
success: change accepted.
set radio-profile countermeasures
Caution: Countermeasures affect wireless service on a radio. When an AP radio is sending
countermeasures, the radio is disabled for use by network traffic, until the radio finishes
sending the countermeasures.
Enables or disables countermeasures for on the DWL-8220AP radios managed by a radio
profile. Countermeasures are packets sent by a radio to prevent clients from being able to
use rogue access points.
DWL-8220AP radios can also issue countermeasures against interfering devices. An
interfering device is not part of the D-Link network but also is not a rogue. No client connected
to the device has been detected communicating with any network entity listed in the forwarding
database (FDD) of any DWS-1008 switch in the MobileLAN. Although the interfering
device is not connected to your network, the device might be causing RF interference with
DWL-8220AP radios.
Syntax:
Defaults:
Access:
Examples:
DWS-1008# set radio-profile radprof3 countermeasures rogue
success: change accepted.
The following command disables countermeasures in radio profile radprof3:
DWS-1008# clear radio-profile radprof3 countermeasures
success: change accepted.
D-Link Systems, Inc.
The beacon interval for DWL-8220AP radios is 100 ms by default.
Enabled
You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command.
The following command changes the beacon interval for radio profile
rp1 to 200 ms:
set radio-profile name countermeasures {all | rogue}
Countermeasures are disabled by default.
Enabled
The following command enables countermeasures in radio profile radprof3 for
rogues only:
Access Point Commands
186