D-Link DWS-1008 Cli Reference Manual page 193

DWS-1008 CLI Reference Guide
Usage:
Examples:
DWS-1008# set radio-profile rp1 rts-threshold 1500
success: change accepted.
set radio-profile service-profile
Maps a service profile to a radio profile. All radios that use the radio profile also use the
parameter settings, including SSID and encryption settings, in the service profile.
Syntax:
radio-profile
service-profile
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
set radio-profile short-retry
Changes the short retry threshold for the DWL-8220AP radios in a radio profile. The short
retry threshold specifies the number of times a radio can send a short unicast frame without
receiving an acknowledgment.
Syntax:
name
threshold
D-Link Systems, Inc.
You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command.
The following command changes the RTS threshold for radio profile rp1 to
1500 bytes:
set radio-profile name service-profile name
Radio profile name of up to 16 alphanumeric characters, name with no
spaces.
Service profile name of up to 16 alphanumeric characters, name with
no spaces.
A radio profile does not have a service profile associated with it by default.
In this case, the radios in the radio profile use the default settings for
parameters controlled by the service profile.
Enabled
You must configure the service profile before you can map it to a radio profile.
You can map the same service profile to more than one radio profile. You
must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command.
The following command maps service-profile wpa_clients to radio profile rp2:
set radio-profile name short-retry threshold
Radio profile name.
Number of times the radio can send the same short unicast frame. You can
enter a value from 1 through 15.
Access Point Commands
192