D-Link DWS-1008 Cli Reference Manual page 174

DWS-1008 CLI Reference Guide
ap port-list
dap dap-num
dapauto
radio 1
radio 2
power-level
Defaults:
Access:
Examples:
DWS-1008# set ap 5 radio 1 auto-tune max-power 12
success: change accepted.
set {ap | dap} radio auto-tune max-retransmissions
Sets the maximum percentage of client retransmissions a radio can experience before RF
Auto-Tuning considers changing the channel on the radio.A high percentage of retransmissions
is a symptom of interference on the channel.
Syntax:
auto-tunemax-retransmissions retransmissions
ap port-list
dap dap-num
dapauto
D-Link Systems, Inc.
List of ports connected to the DWL-8220AP access points on
which to set the maximum power.
Number of a Distributed AP on which to set the maximum
power.
Sets the maximum power for radios configured by the
DWL-8220AP configuration template.
Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
Maximum power setting RF Auto-Tuning can assign to the radio,
expressed as the number of decibels in relation to 1 milliwatt
(dBm). You can specify a value from 1 up to the maximum value
allowed for the country of operation. The power-level can be a
value from 1 to 20.
The default maximum power setting that RF Auto-Tuning can set on a radio
is the highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower.
Enabled.
The following command sets the maximum power that RF Auto-Tuning can
set on radio 1 on the DWL-8220AP access point on port 5 to 12 dBm.
set {ap port-list | dap {dap-num | auto}} radio {1 | 2}
List of ports connected to the DWL-8220AP access points on which to
set the maximum retransmissions.
Number of a Distributed AP on which to set the maximum
retransmissions.
Sets the maximum retransmissions for radios configured by the
DWL-8220AP configuration template.
Access Point Commands
173