D-Link DWS-1008 Cli Reference Manual page 194

DWS-1008 CLI Reference Guide
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp1 short-retry 3
success: change accepted.
set radio-profile wmm
Disables or reenables Wi-Fi Multimedia (WMM) on the DWL-8220AP radios in a radio
profile.
Syntax:
name
enable
disable
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile radprofsvp wmm disable
success: change accepted.
set service-profile auth-dot1x
Disables or reenables 802.1X authentication of Wi-Fi Protected Access (WPA) clients by
DWL-8220AP radios, when the WPA information element (IE) is enabled in the service profile
that is mapped to the radio profile that the radios are using.
D-Link Systems, Inc.
The default short unicast retry threshold for DWL-8220AP radios is 5
attempts.
Enabled
You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command.
The following command changes the short retry threshold for radio profile
rp1 to 3:
set radio-profile name wmm {enable | disable}
Radio profile name.
Enables WMM.
Disables WMM.
WMM is enabled by default.
Enabled
When WMM is disabled, DWL-8220AP forwarding prioritization is optimized
for SpectraLink Voice Priority (SVP) instead of WMM, and the DWL-8220AP
does not tag packets it sends to the switch. Otherwise, classification and
tagging remain in effect. If you plan to use SVP or another
non-WMM type of prioritization, you must configure ACLs to tag the packets.
The following command disables WMM in radio profile radprofsvp:
Access Point Commands
193