Igmp Snooping Commands - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Use Internet Group Management Protocol (IGMP) snooping commands to configure and
manage multicast traffic reduction on a switch.
clear igmp statistics
Clears IGMP statistics counters on one VLAN or all VLANs on a switch and resets them to
0.
Syntax: clear igmp statistics
vlan vlan-id VLAN name or number. If you do not specify a
Defaults: None.
Access: Enabled.
Examples: The following command clears IGMP statistics for all VLANs:
DWS-1008# clear igmp statistics
IGMP statistics cleared for all vlans
set igmp
Disables or reenables IGMP snooping on one VLAN or all VLANs on a switch.
Syntax: set igmp
enable
disable
vlan vlan-id VLAN name or number. If you do not specify a
Defaults: IGMP snooping is enabled on all VLANs by default.
Access: Enabled.
Examples: The following command disables IGMP snooping on VLAN orange:
D-Link Systems, Inc.

IGMP Snooping Commands

vlan vlan-id
[
VLAN, IGMP statistics are cleared for all VLANs.
enable | disable} [vlan vlan-id]
{
Enables IGMP snooping.
Disables IGMP snooping.
VLAN, IGMP snooping is disabled or reenabled
on all VLANs.
IGMP Snooping Commands
]
252